CD DVD glossy oil coating machine

单价: US $855 US $985.00
数量:

商品已添加至购物车

个货品在你的购物车

描述

Specifications

CD DVD glossy oil coating machine
1.Waterproof completely
2.10-15 seconds/ piece
3.Refresh and stable the colors

 

CD /DVD glossy oil coating machine  

 

                        It  can print more than 800pcs per hour.

                       4kg liquid can make about 100000 pcs CD

 

Specification:

Disc working width   140mm
Rated voltage   220V  /110V
Frequency   50HZ-60HZ  
Power   450W   
Machine size   550*400*220mm (length* width* height)
Carton size   640*480*300mm (length* width* height)  
working temperature   15-35°C  
Coating speed   4m/min, 10-15 seconds/piece disc
Liquid consumption   8ml/sqm   150-200 sqm /kg
Lamp Lifetime   800hours

 

 

3. Installation procedures (how to use):

(1) Take out machine and put it on the flat table. There is 8 machine angle (black color) and screws, install them into every angle (small hole) at the bottom of machine and disc tray seperately.  

 

 (2)Pour glossy oil into Liquid storage tank (liquid depth can not be more than 1.5cm). And put tank under rubber roller(red color), then put Pipette into tank.

 

3) Plug in (connected machine with power line and socket). Open three switch (right side is main switch, middle is UV lamp switch, left side is circulated liquid switch), then machine stars working. UV lamp needs warming, let machine tick over around 3minutes in advance. After that, you can start coating CD/DVD after oil poured over the entire rubber roller.

 

(4)For 1st time using, if you still can not find glossy oil on the rubber roller after machine opening 3-5minutes, it means there is some air in the circulated pump (the exit of liquid) so that oil can not pour out. At this time, you can use syringe to deflate the air outwards from the exit of pipette.

 

(5) Put one disc on the tray(words upward), and push disc into the bottom of rubber roller slowly, the machine will coat automatically by itself, the disc will be sent out from the back of the machine once finished

 

(6) If you feel coated oil is too thin or too thick, you can use hexagon wrench to adjust the gap of two rubber roller. Firstly open the cover which is above rollers, you can see clearly there are 2 small aluminum on both side in the front of roller, and there are 2 small holes. Pls put hexagon wrench into the hole, make it rotated clockwise if you need coated oil thin, the gap between rollers will be narrow. If you need coated oil thick, you can make it rotated counter clockwise, the gap will be wider.

 

(7)If not to use the machine for long time, you’d better clear rubber rollers before you store it.

 

商品图片